-
Archives
- July 2020
- June 2020
- December 2019
- August 2019
- April 2019
- March 2019
- February 2019
- July 2016
- June 2016
- April 2016
- January 2016
- November 2015
- October 2015
- September 2015
- August 2015
- July 2015
- June 2015
- May 2015
- April 2015
- March 2015
- February 2015
- January 2015
- November 2014
- October 2014
- September 2014
- August 2014
- July 2014
- June 2014
- May 2014
- April 2014
- March 2014
- February 2014
- January 2014
- November 2013
-
Meta
Monthly Archives: February 2019
OpenWave #3 : First rotating arm test results
The breadboard circuit has been attached attached to the end of a rotating arm and it’s streaming data back to a PC. So just as a recap, the breadboard contains a teensy 3.6, a BNO55 9DOF IMU sensor and a … Continue reading
Posted in OpenWave
Leave a comment
OpenWave #2 : Rotating arm and breadboard circuit started
Some decent progress has been made since the last blog post. See the image of the breadboard below which shows the current state of the electronics: The small blue pcb with the four mounting holes is the BNO55 breakout board … Continue reading
Posted in OpenWave
Leave a comment
OpenWave : Development of an Open-Source and Low-cost wave sensor
Post #1 (2nd February 2019) This blog post will document the process of developing a wave sensor which I’m calling OpenWave for use on data buoys such as the one shown below: Ocean wave measurement has a wide range of … Continue reading