Skip to content

wattnotions

fast documentation of hardware and software projects

  • Home
  • beginner

Archives

beginner

  • FPGA
  • Papilio One

Papilio One : Flashing an LED at a specific frequency

Shane Ormonde9 years ago9 years ago03 mins

To flash an LED at a specific frequency we need to divide the input clock frequency. In VHDL this can be done using counters. The Papilio One FPGA board comes with a 32MHz oscillator. 32Mhz means 32 million pulses per second, if you wanted to divide this down to 1Hz you could just set an…

Read More
  • FPGA
  • Papilio One

Papilio One FPGA board , using a switch to turn on an LED

Shane Ormonde10 years ago8 months ago01 mins

Put this together just to start learning a bit about VHDL coding. The logic is simple, if input P4 (the switch) is low, output P3 (the LED) is high, and vice versa. The circuit diagram is shown below:

Read More
  1. wattnotions on Messing about with trilaterationSeptember 27, 2023

    Not unnecessarily complicated enough :D

  2. Mikhail Grushinskiy on Messing about with trilaterationSeptember 26, 2023

    Why don’t you just use GPS with 2 cm accuracy which is achievable with RTKLib?

  3. Maria on Low power magnetic hold and release mechanismAugust 25, 2023

    From where i can read out more about it. Do you have any suggestive readings?

  4. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would also need fast Fourier transform to find out waves frequently to use it as reference point to give…

  5. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would need wind sensor real-time data. You would need to tilt compensate wind data from real time IMU data.…

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 26 other subscribers

Newsmatic - News WordPress Theme 2023. Powered By BlazeThemes.