Skip to content

wattnotions

fast documentation of hardware and software projects

  • Home
  • drawing machine

Archives

drawing machine

  • C
  • Microcontrollers
  • pic microcontrollers
  • Plotters
  • Projects

Second attempt at making an x-y plotter (TinyPlotter)

Shane Ormonde10 years ago8 months ago21 mins

This plotter was built using parts from cd disc drives. The parts that actually control the motion are the steppers in the cd drives. The steppers are normally used to move a laser diode back and forth over the disc to read it. For this project, a separate disc drive was attached perpendicular to the…

Read More
  1. wattnotions on Messing about with trilaterationSeptember 27, 2023

    Not unnecessarily complicated enough :D

  2. Mikhail Grushinskiy on Messing about with trilaterationSeptember 26, 2023

    Why don’t you just use GPS with 2 cm accuracy which is achievable with RTKLib?

  3. Maria on Low power magnetic hold and release mechanismAugust 25, 2023

    From where i can read out more about it. Do you have any suggestive readings?

  4. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would also need fast Fourier transform to find out waves frequently to use it as reference point to give…

  5. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would need wind sensor real-time data. You would need to tilt compensate wind data from real time IMU data.…

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 26 other subscribers

Newsmatic - News WordPress Theme 2023. Powered By BlazeThemes.