Skip to content

wattnotions

fast documentation of hardware and software projects

  • Home
  • k40

Archives

k40

  • Hardware
  • laser cutter
  • youtube

k40 40w chinese laser cutter review – VIDEO

wattnotions8 years ago8 months ago21 mins
Read More
  • laser cutter

k40 laser cutter : dial for laser power knob

Shane Ormonde8 years ago8 years ago71 mins

The power adjust knob on this k40 laser cutter didn’t have a dial of any sort so it was hard to set power values for different materials like cardboard and acrylic. Here is a picture of the dial: To cut it out you could laser cut and etch it or print it out on paper…

Read More
  1. wattnotions on Messing about with trilaterationSeptember 27, 2023

    Not unnecessarily complicated enough :D

  2. Mikhail Grushinskiy on Messing about with trilaterationSeptember 26, 2023

    Why don’t you just use GPS with 2 cm accuracy which is achievable with RTKLib?

  3. Maria on Low power magnetic hold and release mechanismAugust 25, 2023

    From where i can read out more about it. Do you have any suggestive readings?

  4. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would also need fast Fourier transform to find out waves frequently to use it as reference point to give…

  5. Mikhail Grushinskiy on OpenWave – take 2May 28, 2023

    You would need wind sensor real-time data. You would need to tilt compensate wind data from real time IMU data.…

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 26 other subscribers

Newsmatic - News WordPress Theme 2023. Powered By BlazeThemes.